Spesialis Elektronik – NTI E-LLS-SF-10CM Stainless Steel Vertical Liquid Level Float Switch
- Vertically mounted float switch – install in the top or bottom of the tank (inside of the tank).
- Magnets within the float actuate a highly reliable and repeatable hermetically sealed reed switch as the float rises and lowers with liquid level.
- Single-pole single-throw (SPST) circuitry.
- Configure for normally open or normally closed circuit connection.
- When installed on top of the tank and used for sensing when liquid rises to a certain level (default setting), the sensor will be “normally closed” and will open when the liquid reaches that level.
- When installed on the bottom of the tank and used for sensing the drop in the liquid level beyond a certain point, the sensor will be “normally open” and will close when the liquid drops to that level.
- To change the default setting to “normally open”, simply remove the bottom clip; remove, flip and replace the float; and reinstall the clip.
- Configure for normally open or normally closed circuit connection.
- IP68-rated water and dust protection.
- Max pressure: 217.5 psi (1.5 MPa)
- Float specific gravity: 0.7
- Material: SUS304 /SUS316L stainless steel
- Gasket material: NBR
- Cable length: 15 in (381 mm)
- Wire gauge: 26 AWG
- Wire type: Teflon
- Includes two gel-filled butt splice connectors for extending the cable length up to 1,000 feet.
- Connect to digital input or RJ45 sensor port on an E-2D/5D/16D.
- To connect to the RJ45 inputs, use CAT5/5e/6 cable terminated at one end with RJ45 connector. Connect the un-terminated end to the sensor cables using the included butt splice connectors.
- Float Diameter: 1.1 in (28 mm)
- Stem length:
- E-LLS-SF-10CM: 3.93 in (100 mm)
- E-LLS-SF-25CM: 9.84 in (250 mm)
- Operating temperature: -4 to 194°F (-20 to 90°C).
- Electrical rating: AC 220V/1A; DC 24V/0.5A
- Mounting thread: M10x1.5
Ulasan
Clear filtersBelum ada ulasan.